Got a new notebook (HP ProBook 445 G10) and wanted to see if imaging the system from inside of BootIt works fine.
When I'm at the last step of the image creation process there is the button "Show Command".
Clicked on it and it took literally two minutes before the "Command Line" window showed up.
Is that normal when doing this from inside BootIt?
When I do the same with IFL (within the CLI gui) the command is displayed instantly...
I'm using v1.44 of BootIt
The command displayed looks like:
Code: Select all
IMAGEU.EFI /b /d:{<GUID>}@0x1,0x2,0x3,0x4 /f:{<GUID>}@0x6:"\Win10_x64" /log:0 /rb:4
Code: Select all
0x1 = EFI ("System") partition
0x2 = MSR partition
0x3 = Windows system partition (e.g. 64 GB for Windows 10)
0x4 = Windows recovery partition
0x5 = IFL partition
0x6 = Data partition (ntfs)
Additionally, when I finally start the image creation process, it does (visually) nothing for at least a full minute before something happens.
It then takes another 4 minutes to backup ~10,5 GB.
Doing this from IFL there is no initial rampup time, it begins immediately and only takes about 20 seconds to finish...
Regards,
highend