TBCMD not recognizing my drives
Posted: Fri Oct 15, 2021 8:00 pm
Decided to revisit tbscript and improve on some of my scripts I wrote years ago.
Immediately noticed that all the scripts I was using to access the Bootit EMBR partition no longer work?
For a short example...
gethdinfo fails to detect any drive.
I also tried to run from TBCMD
and that just gives me a "Invalid drive" response?
I did recently wipe my drive to re-install win 10 and upgraded bootit bm as well.
That all went fine. I can boot to all my partitions just fine and creating and restoring images
works perfectly. I'm at a loss trying to figure out why gethdinfo() is no longer working though??
Any suggestions? Thanks, William
Immediately noticed that all the scripts I was using to access the Bootit EMBR partition no longer work?
For a short example...
Code: Select all
sub main()
dr=getdrive() ; This works as expected
printl("current drive is ",dr)
getdrvltrinfo()
h=gethdinfo(0) ; This does not work
printl("the HD number is ",h.num)
getdrvltrinfo(0)
getkey("Press Any Key To Exit...")
end sub
I also tried to run from TBCMD
Code: Select all
list hd 0
I did recently wipe my drive to re-install win 10 and upgraded bootit bm as well.
That all went fine. I can boot to all my partitions just fine and creating and restoring images
works perfectly. I'm at a loss trying to figure out why gethdinfo() is no longer working though??
Any suggestions? Thanks, William