Page 1 of 1
EMBR Out of Sync
Posted: Tue Jul 17, 2018 3:53 pm
by GordonM
I am trying to image two partitions on an old drive. In Windows Explorer (Windows 10) they show as drives H: and J:. If I try to image using IFW, H: shows up for imaging but J: does not. Instead there is an entry that says HD3 EMBR (out of sync) 149.05 GB (it is a 160GB disk). Is there anything that I can do about this to be able to image J:?
Thank you
GordonM
Re: EMBR Out of Sync
Posted: Tue Jul 17, 2018 6:45 pm
by Eric
You can correct the EMBR (so Sync it with the MBR) with BootIt BM (or UEFI if you have).
Re: EMBR Out of Sync
Posted: Tue Jul 17, 2018 7:24 pm
by GordonM
Thank you for the reply. I was just about to post that I have found instructions at
https://www.terabyteunlimited.com/kb/article.php?id=451. I don't have BoouIt BM but I have BootIt NG, which seems to do the job.
Thank you
GordonM
Re: EMBR Out of Sync
Posted: Wed Jul 18, 2018 4:46 am
by TeraByte Support
If I recall, change disk type to mbr may do it as well.