3 User (?) License
2 Devices, Lenovo x220 and T440, work just fine with
IFW despite being multi-boot with LinuxMint.
1 Device, in process of replacing, lost a motherboard during storm.
Thankfully just did a backup (using IFW).
Current Victim is an Asus Q87T/CSM -based system, 6TB IronWolf Drive, no RAID.
Windows 10 installed, updates are current as of this message.
I still consider this Win10 clean, at least same software running on it as the others
without problems. 1 Change is addition of a 6TB IronWolf drive, currently partitioned
as 250GB System, 350GB Storage, balance is unused / unpartitioned / unformatted.
Drive is UEFI.
What happens is that I was able to install IFW v2 without issues. IFW Notify works.
PartInfo works and displays what is expected. When IFW is started, I get the prompt
from nag-nanny about wanting to run this program (starting as Administrator), choose yes,
and it appears to start but then it dies without error message.
I have checked logs (windows, application, system, etc)and no error messages are being
stored there.
What could be going on? Is there a log file applicable to IFW somewhere in addition to system
logs?
Thanks!
IFW v2 Won't start - Windows 10
-
- Posts: 1644
- Joined: Fri Aug 12, 2011 12:51 am
Re: IFW v2 Won't start - Windows 10
Assuming you're using 2.99, you can try running the 32-bit version (imagew.exe) and see if that works.
Otherwise, you would need to upgrade to V3 (last release of V2 was early 2016 and is no longer supported):
https://www.terabyteunlimited.com/kb/article.php?id=611
Otherwise, you would need to upgrade to V3 (last release of V2 was early 2016 and is no longer supported):
https://www.terabyteunlimited.com/kb/article.php?id=611