Page 1 of 1

"Select Additional Tasks" Screen Not Displaying

PostPosted: Sat Dec 21, 2019 9:52 pm
by Hadron
Hi.

I don't know what has happened to cause this, but the "Select Additional Tasks" screen is no longer displaying when I install a new version of TeraByte Drive Image Backup And Restore Suite.
Any ideas what I need to do to re-enable it?

Re: "Select Additional Tasks" Screen Not Displaying

PostPosted: Sun Dec 22, 2019 7:40 pm
by TeraByte Support
You installed in simple operations mode. You'd need to install in
traditional mode.


On 12/21/2019 8:52 PM, Hadron wrote:
> Hi.
>
> I don't know what has happened to cause this, but the "Select Additional Tasks" screen is no longer displaying when I install a new version of TeraByte Drive Image Backup And Restore Suite.
> Any ideas what I need to do to re-enable it?
>
>


Re: "Select Additional Tasks" Screen Not Displaying

PostPosted: Sun Dec 22, 2019 9:10 pm
by Hadron
Hi there.

There is no option to choose between modes in the installation.

Re: "Select Additional Tasks" Screen Not Displaying

PostPosted: Sun Dec 22, 2019 9:46 pm
by Hadron
Simple Operations is not selected in the program settings.

[attachment=0]IFW Settings.png[/attachment]

Re: "Select Additional Tasks" Screen Not Displaying

PostPosted: Sun Dec 22, 2019 10:52 pm
by Hadron
This is the Additional Tasks screen that I can't get at installation.

[attachment=1]TeraByte IFW Additional Tasks Setup 01.png[/attachment]
[attachment=0]TeraByte IFW Additional Tasks Setup 02.png[/attachment]

Re: "Select Additional Tasks" Screen Not Displaying

PostPosted: Mon Dec 23, 2019 9:36 am
by TeraByte Support
On 12/22/2019 8:10 PM, Hadron wrote:
> Hi there.
>
> There is no option to choose between modes in the installation.
>
>
uninstall then reinstall.


Re: "Select Additional Tasks" Screen Not Displaying

PostPosted: Mon Dec 23, 2019 2:06 pm
by Hadron
Oh.

Thank you.