EMBR Out of Sync

User discussion and information resource forum for Image products.
Post Reply
GordonM
Posts: 35
Joined: Thu Dec 22, 2011 2:40 pm

EMBR Out of Sync

Post by GordonM »

I am trying to image two partitions on an old drive. In Windows Explorer (Windows 10) they show as drives H: and J:. If I try to image using IFW, H: shows up for imaging but J: does not. Instead there is an entry that says HD3 EMBR (out of sync) 149.05 GB (it is a 160GB disk). Is there anything that I can do about this to be able to image J:?

Thank you
GordonM
Eric
Posts: 224
Joined: Mon Sep 05, 2011 6:53 pm
Location: France

Re: EMBR Out of Sync

Post by Eric »

You can correct the EMBR (so Sync it with the MBR) with BootIt BM (or UEFI if you have).
GordonM
Posts: 35
Joined: Thu Dec 22, 2011 2:40 pm

Re: EMBR Out of Sync

Post by GordonM »

Thank you for the reply. I was just about to post that I have found instructions at https://www.terabyteunlimited.com/kb/article.php?id=451. I don't have BoouIt BM but I have BootIt NG, which seems to do the job.

Thank you
GordonM
TeraByte Support
Posts: 3598
Joined: Thu May 05, 2011 10:37 pm

Re: EMBR Out of Sync

Post by TeraByte Support »

If I recall, change disk type to mbr may do it as well.
Post Reply