Hi - It seems a trivial thing, but I haven't found any hits on this...
I use IFW to backup to (the same) folder on my NAS via an \\UNC path
Expanding the Entire Network, and then entering my UNC at <<enter unc path here>>, is a bit of a pain
but I can't see any obvious way to get IFW to remember the last backup destination used ? (so that I only need to enter the UNC if it changes)
Any suggestions ?
-Tom
IFW Remember backup destination?
-
- Posts: 3634
- Joined: Thu May 05, 2011 10:37 pm
Re: IFW Remember backup destination?
in the ui, it remembers last drive letter and dir if you just select windows
drives, but it still doesn't remember a unc (at least not currently).
"Tom__H" wrote in message news:15040@public.image...
Hi - It seems a trivial thing, but I haven't found any hits on this...
I use IFW to backup to (the same) folder on my NAS via an \\UNC path
Expanding the Entire Network, and then entering my UNC at >, is a bit of a pain
but I can't see any obvious way to get IFW to remember the last backup
destination used ? (so that I only need to enter the UNC if it changes)
Any suggestions ?
-Tom
drives, but it still doesn't remember a unc (at least not currently).
"Tom__H" wrote in message news:15040@public.image...
Hi - It seems a trivial thing, but I haven't found any hits on this...
I use IFW to backup to (the same) folder on my NAS via an \\UNC path
Expanding the Entire Network, and then entering my UNC at >, is a bit of a pain
but I can't see any obvious way to get IFW to remember the last backup
destination used ? (so that I only need to enter the UNC if it changes)
Any suggestions ?
-Tom