I am using Image for Windows to duplicate drives using the "Copy" feature and also performing byte-validation. I need to test the byte validation feature to show my boss that it works properly. Is there a way to perform only this task so I can duplicate one drive to another, validate it, then make a change to the destination and show that validation fails?
Thanks in advance!
IFW Drive Copy and Verify
-
- Posts: 3616
- Joined: Thu May 05, 2011 10:37 pm
Re: IFW Drive Copy and Verify
you'd have to use a disk editor and modify a sector on the target disk error
after it had been restored, but before verified, and also would have to be
one in use.
"pjb926" wrote in message news:852@public.image...
I am using Image for Windows to duplicate drives using the "Copy"
feature and also performing byte-validation. I need to test the byte
validation feature to show my boss that it works properly. Is there a way
to perform only this task so I can duplicate one drive to another, validate
it, then make a change to the destination and show that validation fails?
Thanks in advance!
after it had been restored, but before verified, and also would have to be
one in use.
"pjb926" wrote in message news:852@public.image...
I am using Image for Windows to duplicate drives using the "Copy"
feature and also performing byte-validation. I need to test the byte
validation feature to show my boss that it works properly. Is there a way
to perform only this task so I can duplicate one drive to another, validate
it, then make a change to the destination and show that validation fails?
Thanks in advance!