mashedmitten,
I may have not been clear - I know better then to take an image from one system and use it on a different system. The Images were all taken from a Compaq CQ57 Laptop and written to an SSD that was going back into the same Compaq laptop. At one point I used a different system to restore an Image File (made from the Compaq) to the SSD to go back into the Compaq.
So the last page options - Scale to Fit is needed because the drives are slightly different sizes.
Should I try without "Align to Target" and "Write Standard MBR Code"?
From the manual "Align to Target" is overridden by "Align Partitions on 1 MiB Boundaries".
From the manual it does look like I shouldn't use "Write Standard MBR Code".