Page 1 of 1
Consistent b-f-b failures on changes-only backups
Posted: Wed Oct 05, 2016 1:38 pm
by Scott
Lately, I've been able to consistently do full backups with no issues at all, but changes-only backups consistently give b-f-b failures.
I've tried all the familiar fixes. I'm wondering if somehow the fact that I recently encrypted the destination drive with Bitlocker could be a cause. I have no idea why it would, or in particular why it would impact only changes-only backups, though.
Nothing else has changed except that I've installed the God-forsaken Win10 Anniversary Update.
Re: Consistent b-f-b failures on changes-only backups
Posted: Wed Oct 05, 2016 3:55 pm
by TeraByte Support
what drive type?
"Scott" wrote in message news:12614@public.image...
Lately, I've been able to consistently do full backups with no issues at
all, but changes-only backups consistently give b-f-b failures.
I've tried all the familiar fixes. I'm wondering if somehow the fact that I
recently encrypted the destination drive with Bitlocker could be a cause. I
have no idea why it would, or in particular why it would impact only
changes-only backups, though.
Nothing else has changed except that I've installed the God-forsaken Win10
Anniversary Update.
Re: Consistent b-f-b failures on changes-only backups
Posted: Wed Oct 05, 2016 9:19 pm
by Scott
SSD source, 4-TB HDD dest.
Forgot to mention I've so far only tried VSS.
Re: Consistent b-f-b failures on changes-only backups
Posted: Fri Oct 07, 2016 6:05 am
by TeraByte Support
what ssd drive? those without DRAT and Win10AU seem to have more issues.
Win10 must allocate a lot more items that are not written for its temp
files.
"Scott" wrote in message news:12619@public.image...
SSD source, 4-TB HDD dest.
Forgot to mention I've so far only tried VSS.
Re: Consistent b-f-b failures on changes-only backups
Posted: Fri Oct 07, 2016 5:41 pm
by Scott
It's a Samsung 840 Pro, which is from early 2013.
Re: Consistent b-f-b failures on changes-only backups
Posted: Sat Oct 08, 2016 10:53 pm
by TeraByte Support
you'd have to check if it supports DRAT or not, depends on the firmware
version and model. Some PRO's do, the 830's support DRAT.
"Scott" wrote in message news:12637@public.image...
It's a Samsung 840 Pro, which is from early 2013.
Re: Consistent b-f-b failures on changes-only backups
Posted: Sun Oct 09, 2016 1:09 am
by Scott
I just ran a changes-only backup with "Disable Trim" enabled (previously, I never had that option enabled), and it completed without issue. Not sure if this was just a coincidence.