Page 1 of 1

Divide Overflow

PostPosted: Thu Mar 14, 2013 10:26 am
by loubie
I'm tryng BM, for which I created a startup floppy disk for Partition Work.

I boot the PC from the floppy, but while it's still in the DOS screen, after "Starting..." and the Bare Metal banner, it throws a Divide Overflow! error and stops.

The configuration of the floppy is very plain vanilla with none of the optional settings checked, Mouse Enabled, VESA, 800x600 no IFD.

Any suggestions?

Re: Divide Overflow

PostPosted: Thu Mar 14, 2013 12:53 pm
by TeraByte Support
check your BIOS settings for the drive or consider updating to the latest
BIOS or reset BIOS settings to optimal values.

"loubie" wrote in message news:4935@public.bootitbm...

I'm tryng BM, for which I created a startup floppy disk for Partition Work.

I boot the PC from the floppy, but while it's still in the DOS screen, after
"Starting..." and the Bare Metal banner, it throws a Divide Overflow! error
and stops.

The configuration of the floppy is very plain vanilla with none of the
optional settings checked, Mouse Enabled, VESA, 800x600 no IFD.

Any suggestions?