I'm tryng BM, for which I created a startup floppy disk for Partition Work.
I boot the PC from the floppy, but while it's still in the DOS screen, after "Starting..." and the Bare Metal banner, it throws a Divide Overflow! error and stops.
The configuration of the floppy is very plain vanilla with none of the optional settings checked, Mouse Enabled, VESA, 800x600 no IFD.
Any suggestions?
Divide Overflow
-
- Posts: 3622
- Joined: Thu May 05, 2011 10:37 pm
Re: Divide Overflow
check your BIOS settings for the drive or consider updating to the latest
BIOS or reset BIOS settings to optimal values.
"loubie" wrote in message news:4935@public.bootitbm...
I'm tryng BM, for which I created a startup floppy disk for Partition Work.
I boot the PC from the floppy, but while it's still in the DOS screen, after
"Starting..." and the Bare Metal banner, it throws a Divide Overflow! error
and stops.
The configuration of the floppy is very plain vanilla with none of the
optional settings checked, Mouse Enabled, VESA, 800x600 no IFD.
Any suggestions?
BIOS or reset BIOS settings to optimal values.
"loubie" wrote in message news:4935@public.bootitbm...
I'm tryng BM, for which I created a startup floppy disk for Partition Work.
I boot the PC from the floppy, but while it's still in the DOS screen, after
"Starting..." and the Bare Metal banner, it throws a Divide Overflow! error
and stops.
The configuration of the floppy is very plain vanilla with none of the
optional settings checked, Mouse Enabled, VESA, 800x600 no IFD.
Any suggestions?