Knowledge Base Glossary       Exit
(how to) Search  

Browse by Category
Knowledge Base > Products > Shared Issues > RAID Support

RAID Support

RAID support information for TeraByte's programs is listed below. In general, hardware and firmware-based RAID is supported; OS and software RAID is not, with several exceptions.

Note: If you have a RAID configuration you're not sure about, you can use the trial version (or full version, if purchased) of the program to check if it's supported.

BootIt Bare Metal

  • Hardware and firmware RAID support is provided by the system BIOS.
  • OS and software-based RAID is not supported.

Image for DOS

  • Hardware and firmware RAID support is provided by the system BIOS.
  • OS and software-based RAID is not supported.

Image for Linux

  • Supports most RAID configurations, including hardware RAID, firmware-based RAID, and Linux Software RAID.
  • Certain LVM/RAID configurations may not be supported.
  • Other OS and software-based RAID is not supported (e.g. Windows Dynamic Disk RAID).

Image for Windows

  • Supports hardware and firmware-based RAID.
  • OS and software-based RAID is not supported (e.g. Dynamic Disk RAID, Linux Software RAID).
  • Saving a backup to or reading a backup from a Dynamic Disk RAID is supported.
  • For the Image for Windows recovery media (TBWinRE, TBWinPE), many standard RAID drivers are included. If necessary, when creating the recovery media, Windows RAID drivers can be added.

How helpful was this article to you?


powered by Lore