Knowledge Base Glossary       Exit
(how to) Search  

Browse by Category
Knowledge Base > Products > Image for Windows > General Information > Restoring a Full Drive Backup Using a BartPE Disk

Restoring a Full Drive Backup Using a BartPE Disk

Important Note: BartPE is obsolete. The BartPE environment is based on Windows XP and may not build or function correctly on current/newer systems. Additionally, the Bart PE Builder program and documentation is no longer available from its original source. Using TBWinRE or TBWinPE is recommended.

Because you can't use Image for Windows to restore over a Windows Operating System that is in use, you will normally restore a full drive backup image using an Image for DOS or Image for Linux boot disk. However, you can also use Image for Windows on a TBWinRE, TBWinPE, or BartPE Disk to perform the restore. The tutorial linked below takes you through that process using BartPE.

Restoring a Full Drive Backup Using a BartPE Disk


How helpful was this article to you?


powered by Lore