Knowledge Base Glossary       Exit
(how to) Search  

Browse by Category
Knowledge Base > Products > Free Utilities > PHYLock > How to Perform an Unattended Installation of PHYLock

How to Perform an Unattended Installation of PHYLock

To perform an unattended installation of PHYLock:
  1. Download the standalone PHYLock installer.  (A version of PHYLock for Image for Windows V1 is also available).

  2. Extract the PHYLock archive to a folder on your hard drive.  (We'll use the folder "D:\Temp" as an example.)

  3. Open a command prompt and navigate to the folder where you extracted the PHYLock archive.  To change the current directory, issue the applicable "cd" command.  Following our example, you would enter the command:

    cd /d "D:\Temp"

  4. Enter the following command into the command prompt window:

    setup /i

How helpful was this article to you?


powered by Lore