Knowledge Base Glossary       Exit
(how to) Search  

Browse by Category
Knowledge Base > Archive > Products > BootIt Next Generation > Problem Solving > BootIt NG Sees Only 8 GB (or Less than the Total Size) of a Hard Drive

BootIt NG Sees Only 8 GB (or Less than the Total Size) of a Hard Drive

The problem is most likely that the system BIOS doesn't support hard drives larger than 8GB (or however big the drive is). To correct this issue:

  1. If your motherboard manufacturer has a BIOS update, install it. The update may have added support for the large hard drive.

  2. If there is no BIOS update available from your motherboard manufacturer then you can check with eSupport.com to see if an update is available that will work for you.

  3. Install an ATA-66/100/etc. controller and move your drives to it. The controller should have a BIOS which will support larger hard drives. If it doesn't support a very large hard drive, there may be firmware updates available at the manufacturer's website. 

  4. The BIOS may need to have the drive controller in LBA mode for the full drive size to be seen. If LBA mode doesn't work and a Normal mode is available, try that.

How helpful was this article to you?


powered by Lore