Knowledge Base Glossary       Exit
(how to) Search  

Browse by Category
Knowledge Base > Archive > Products > BootIt Next Generation > Problem Solving > No ATAPI CD or DVD Drives are Shown on the Work with Partitions Dialog

No ATAPI CD or DVD Drives are Shown on the Work with Partitions Dialog

To solve this problem:

  1. Make sure ATAPI CD Support is enabled in BootIt NG's Settings.

  2. Make sure the drives are connected to the standard mainboard IDE controller, rather than to an on-board RAID controller.

  3. Update the optical drive's firmware, is possible.

  4. If the above check out, then the drive may not be compatible. 

How helpful was this article to you?


powered by Lore