Software RAID and imaging
Software RAID and imaging
Is there any way to get any of the TeraByte imaging products to work with any of the prominent third-party RAID solutions (e.g. FlexRAID, DriveBender, etc.)? I'd like to use one of these solutions, but I must retain the ability to restore an image from the pool.
-
TeraByte Support
- Posts: 3628
- Joined: Thu May 05, 2011 10:37 pm
Re: Software RAID and imaging
In general you're better off with built-in firmware/hardware raid especially
to recover on failure. Firmware RAID controllers can be less than $20. But
if you still wanted to use software based raid then you would need to have
the proper drivers installed and it would need to be transparent at the
level the "drive" was accessed for it would work - TBWinPE/TBWinRE boot disk
you can add drivers to then see how it works
(http://www.terabyteunlimited.com/howto/ (the appendix indicates were to
add drivers)).
"Scott" wrote in message news:8711@public.image...
Is there any way to get any of the TeraByte imaging products to work with
any of the prominent third-party RAID solutions (e.g. FlexRAID, DriveBender,
etc.)? I'd like to use one of these solutions, but I must retain the ability
to restore an image from the pool.
to recover on failure. Firmware RAID controllers can be less than $20. But
if you still wanted to use software based raid then you would need to have
the proper drivers installed and it would need to be transparent at the
level the "drive" was accessed for it would work - TBWinPE/TBWinRE boot disk
you can add drivers to then see how it works
(http://www.terabyteunlimited.com/howto/ (the appendix indicates were to
add drivers)).
"Scott" wrote in message news:8711@public.image...
Is there any way to get any of the TeraByte imaging products to work with
any of the prominent third-party RAID solutions (e.g. FlexRAID, DriveBender,
etc.)? I'd like to use one of these solutions, but I must retain the ability
to restore an image from the pool.