IFW Drive Copy and Verify

User discussion and information resource forum for Image products.
Post Reply
pjb926
Posts: 5
Joined: Thu Dec 08, 2011 4:35 pm

IFW Drive Copy and Verify

Post by pjb926 »

I am using Image for Windows to duplicate drives using the "Copy" feature and also performing byte-validation. I need to test the byte validation feature to show my boss that it works properly. Is there a way to perform only this task so I can duplicate one drive to another, validate it, then make a change to the destination and show that validation fails?

Thanks in advance!
TeraByte Support
Posts: 3598
Joined: Thu May 05, 2011 10:37 pm

Re: IFW Drive Copy and Verify

Post by TeraByte Support »

you'd have to use a disk editor and modify a sector on the target disk error
after it had been restored, but before verified, and also would have to be
one in use.

"pjb926" wrote in message news:852@public.image...

I am using Image for Windows to duplicate drives using the "Copy"
feature and also performing byte-validation. I need to test the byte
validation feature to show my boss that it works properly. Is there a way
to perform only this task so I can duplicate one drive to another, validate
it, then make a change to the destination and show that validation fails?

Thanks in advance!

Post Reply