Password Corruption ?

User discussion and information resource forum for BootIt Bare Metal.

Password Corruption ?

Postby aussieboykie » Fri Apr 06, 2012 2:28 pm

I had not updated BIBM for some time so when 1.08 came out I made a bootable USB key and fired it up. All went well until reboot from my hard drive. I could not enter maintenance mode because BIBM would not accept my password. I had to reboot from USB, switch to HD, and delete the password. As a test, I repeated the process on a second PC and this time I confirmed the password was correct beforehand, just in case my failing memory played a part in any of this. The result was the same.

Regards, AB
aussieboykie
 
Posts: 15
Joined: Fri Oct 28, 2011 8:58 pm

Re: Password Corruption ?

Postby TeraByte Support » Fri Apr 06, 2012 6:01 pm

upgrading from BING or BIBM (which) to BIBM ? There was a problem with BING to BIBM conversion but fixed in 1.02. If BIBM 1.02a or later to BIBM, then email the password you were using along with the version being converted from.
TeraByte Support
 
Posts: 2325
Joined: Thu May 05, 2011 3:37 pm

Re: Password Corruption ?

Postby aussieboykie » Fri Apr 06, 2012 11:25 pm

BIBM to BIBM. I can't say for sure what BIBM version was overwritten but it would certainly have been post 1.02a, probably v1.06 or v1.07. No need to email the password... it was cpcms which anyone else who looked after IBM VM systems back in the 70s and 80s will no doubt recognise.

Regards, AB
aussieboykie
 
Posts: 15
Joined: Fri Oct 28, 2011 8:58 pm


Return to BootIt Bare Metal