IFW Drive Copy and Verify

User discussion and information resource forum for Image products.

IFW Drive Copy and Verify

Postby pjb926 » Thu Dec 08, 2011 9:43 am

I am using Image for Windows to duplicate drives using the "Copy" feature and also performing byte-validation. I need to test the byte validation feature to show my boss that it works properly. Is there a way to perform only this task so I can duplicate one drive to another, validate it, then make a change to the destination and show that validation fails?

Thanks in advance!
pjb926
 
Posts: 5
Joined: Thu Dec 08, 2011 9:35 am

Re: IFW Drive Copy and Verify

Postby TeraByte Support » Thu Dec 08, 2011 5:18 pm

you'd have to use a disk editor and modify a sector on the target disk error
after it had been restored, but before verified, and also would have to be
one in use.

"pjb926" wrote in message news:852@public.image...

I am using Image for Windows to duplicate drives using the "Copy"
feature and also performing byte-validation. I need to test the byte
validation feature to show my boss that it works properly. Is there a way
to perform only this task so I can duplicate one drive to another, validate
it, then make a change to the destination and show that validation fails?

Thanks in advance!

TeraByte Support
 
Posts: 2311
Joined: Thu May 05, 2011 3:37 pm


Return to Image for DOS/Linux/Windows