Page 1 of 1

PostPosted: Fri Nov 11, 2016 10:10 pm
by Ed Smith
I have downloaded both BareMetal 1.35 and IFD 3.04 and when I run MakeDisk
and click on Finish, I get an error window with yellow exclamation point
titled "MakeDisk - Image for DOS V3 (GUI)" saying unable to open file
describing it's location.

I get the error also for BareMetal.

I have downloaded both twice now and tried twice thinking it may be a bad
download and same error.

I then tried IFD (GUI) without networking and MakeDisk completed
successfully.

Any suggestions ?

Thanks,
Ed.


Re:

PostPosted: Fri Nov 11, 2016 11:39 pm
by TeraByte Support
download it again.


"Ed" wrote in message news:12843@public.image...

I have downloaded both BareMetal 1.35 and IFD 3.04 and when I run MakeDisk
and click on Finish, I get an error window with yellow exclamation point
titled "MakeDisk - Image for DOS V3 (GUI)" saying unable to open file
describing it's location.

I get the error also for BareMetal.

I have downloaded both twice now and tried twice thinking it may be a bad
download and same error.

I then tried IFD (GUI) without networking and MakeDisk completed
successfully.

Any suggestions ?

Thanks,
Ed.


Re: Re:

PostPosted: Sat Nov 12, 2016 5:38 pm
by Ed Smith
I downloaded them again and now MakeDisk completes without error.

Thanks,
Ed.

"TeraByte Support" wrote in message news:12845@public.image...

download it again.


"Ed" wrote in message news:12843@public.image...

I have downloaded both BareMetal 1.35 and IFD 3.04 and when I run MakeDisk
and click on Finish, I get an error window with yellow exclamation point
titled "MakeDisk - Image for DOS V3 (GUI)" saying unable to open file
describing it's location.

I get the error also for BareMetal.

I have downloaded both twice now and tried twice thinking it may be a bad
download and same error.

I then tried IFD (GUI) without networking and MakeDisk completed
successfully.

Any suggestions ?

Thanks,
Ed.