Page 1 of 1

Setting Up a Restore Partition with EMBR

PostPosted: Wed Nov 09, 2016 2:06 pm
by rkulp
:?: I was going to set up a restore partition on a computer and used BootIT NG to look at the partitions. It had the restore partition on it so I had already started it when I bought the computer but did not finish. It had more than 4 partitions so was using EMBR. I want to remove one, slide the OS partition down and then build the restore using the article "Using MBR.EXE To Set Up A Restore Partition." I'm unable to find anything about doing this with an EMBR and am afraid to remove the EMBR as I just rebuilt the OS (Windows 10) and worry about losing everything.
So, how should I proceed?

Re: Setting Up a Restore Partition with EMBR

PostPosted: Wed Nov 09, 2016 5:42 pm
by TeraByte Support
if you don't use BIBM or BING, boot up to that, get the partition count down
to 4, then change disk type to mbr. Last, go to view mbr, w7 mbr, apply.


"rkulp" wrote in message news:12827@public.image...


![:?:]({SMILIES_PATH}/icon_question.gif)

I was going to set up a restore partition on a computer and used BootIT NG
to look at the partitions. It had the restore partition on it so I had
already started it when I bought the computer but did not finish. It had
more than 4 partitions so was using EMBR. I want to remove one, slide the OS
partition down and then build the restore using the article "Using MBR.EXE
To Set Up A Restore Partition." I'm unable to find anything about doing this
with an EMBR and am afraid to remove the EMBR as I just rebuilt the OS
(Windows 10) and worry about losing everything.
So, how should I proceed?