Page 1 of 1
IFL: Validate not checked if PostValidate=2 in ifl.ini
Posted: Fri Jul 29, 2016 10:29 pm
by Mrx
The manual says that using PostValidate=2 in ifl.ini means IFL will also perform a standard validation, but the GUI does not reflect this as the Validate checkbox is not checked automatically when doing a Backup (only the Validate Byte-for-Byte is checked).
Re: IFL: Validate not checked if PostValidate=2 in ifl.ini
Posted: Fri Jul 29, 2016 10:47 pm
by Mrx
Instead of creating a new topic, I'll post requests for new ifl.ini options here:
RebootWhenCompleted
ShutdownWhenCompleted
I would also like a Restore ini option to specify whether it defaults to using Automatic or Manual.
Re: IFL: Validate not checked if PostValidate=2 in ifl.ini
Posted: Sat Jul 30, 2016 12:09 am
by Brian K
Mrx wrote:
> The manual says that using PostValidate=2 in ifl.ini means IFL will also
> perform a standard validation,
On which page are you seeing this information? PostValidate=2 means Validate Byte-for-Byte.
Re: IFL: Validate not checked if PostValidate=2 in ifl.ini
Posted: Sat Jul 30, 2016 2:01 am
by TeraByte Support(PP)
It's on page 114. Note that it's not necessary to also specify a normal validation when validate byte-for-byte is used since it does both.
Re: IFL: Validate not checked if PostValidate=2 in ifl.ini
Posted: Sat Jul 30, 2016 2:22 am
by Mrx
Ah, I was forgetting that the value can be combined, so to get it to check the Validate box as well I need to have PostValidate=3 (even though it's not necessary).