restore image on several drives with /wco is a problem

User discussion and information resource forum for Image products.
giulia
Posts: 130
Joined: Sun Sep 22, 2013 8:16 am

Re: restore image on several drives with /wco is a problem

Post by giulia »

Brian K wrote:
> Have you checked the Ultra II yet?
yes
both have the same settings reported like the pro
TeraByte Support
Posts: 3598
Joined: Thu May 05, 2011 10:37 pm

Re: restore image on several drives with /wco is a problem

Post by TeraByte Support »

have no clue what that means, but how do you have the drive attached?
directly to sata or via some type of converter (sata to usb). In any case,
with 2.99-00, if the drive reports data via ATA interface and says it
doesn't support TRIM or does support DRAT then the wco option will show up,
otherwise it won't (that means other interfaces won't have that option for
now). You should see the same thing in both linux and windows versions.

"giulia" wrote in message news:11225@public.image...

Brian K wrote:
> Have you checked the Ultra II yet?
yes
both have the same settings reported like the pro

Brian K
Posts: 2214
Joined: Fri Aug 12, 2011 1:11 am
Location: NSW, Australia

Re: restore image on several drives with /wco is a problem

Post by Brian K »

giulia wrote:
> Brian K wrote:
> > Have you checked the Ultra II yet?
> yes
> both have the same settings reported like the pro

giulia,

I assume you mean it shows...

" Bit 14 Deterministic Behavior - Not Supported"
giulia
Posts: 130
Joined: Sun Sep 22, 2013 8:16 am

Re: restore image on several drives with /wco is a problem

Post by giulia »

Brian K wrote:
> giulia wrote:
> > Brian K wrote:
> > > Have you checked the Ultra II yet?
> > yes
> > both have the same settings reported like the pro
>
> giulia,
>
> I assume you mean it shows...
>
> " Bit 14 Deterministic Behavior - Not Supported"
yes
i want to check them with the program hard disk sentinel too
Post Reply