Sun Nov 06, 2011 8:32 am
Sun Nov 06, 2011 10:56 am
Am I supposed to also select 'View MBR' and then select 'Std MBR' , even if there's no EMBR partition visible, and then press Apply?
Sun Nov 06, 2011 12:54 pm
Sun Nov 06, 2011 12:58 pm
Mon Nov 07, 2011 5:52 am
TeraByte Support(PP) wrote:Yes, you would still need to reset the MBR code. The current code is trying to find the EMBR. There doesn't need to be an EMBRM partition on the drive for the EMBR (which is not a partition) or the BootIt MBR code to exist on it. The default (standard) MBR code would try to boot the active partition. When you select the drive, if it still contains an active EMBR, the "Undo EMBR" button will be available under the hard drive selection list. It sounds like you've already done that part.
The default (standard) MBR code would try to boot the active partition.
Mon Nov 07, 2011 9:27 am
Mon Nov 07, 2011 1:28 pm
TeraByte Support(PP) wrote:Basically, all you are doing is replacing the MBR code that tries to access the EMBR with the standard code that tries to boot the active partition. You'll get an error message in either case and the system won't boot. The error message is displayed when the "try" fails -- it doesn't do anything harmful.
phpBB® Forum Software © phpBB Group.
phpBB Mobile by Artodia.