Error: No USB-HDD info after exiting BIBM backup process
Posted: Sun Feb 02, 2014 4:50 pm
I created a BIBM backup from my Win7 partition and had it validated. When I got the message 'Operation completed succesfully' I exited with Alt+R and waited some time in order to see the newly created backup in Work with Partitions. But instead I only saw 'Error Exists' above the empty MBR field and nothing happened.
[Drive 2 info after exiting the Backup process.jpg]
It was only after restart that I saw my Drive 2 (which is my USB destination HDD) info of the new backup. Then everything appeared to be OK.
[Drive 2 info after reboot.jpg]
Now I am somewhat disconcerted by the intermediate error message and I would like to put the following questions:
- How can I be sure that my backup is really valid without actually restoring it? Is there any short test or can I unconditionally trust the carried out validation within the backup process and forget about the intermediate error message?
- What is the reason for that message and how could I have avoided it?
(Editorial note: I do not know how to place the screenshots inline. BBCode is OFF. I do not know how to switch it ON. The preview always showed the Attachment names with the functional characters. So I had to place them at the end, which reversed their order at that.)
[Drive 2 info after exiting the Backup process.jpg]
It was only after restart that I saw my Drive 2 (which is my USB destination HDD) info of the new backup. Then everything appeared to be OK.
[Drive 2 info after reboot.jpg]
Now I am somewhat disconcerted by the intermediate error message and I would like to put the following questions:
- How can I be sure that my backup is really valid without actually restoring it? Is there any short test or can I unconditionally trust the carried out validation within the backup process and forget about the intermediate error message?
- What is the reason for that message and how could I have avoided it?
(Editorial note: I do not know how to place the screenshots inline. BBCode is OFF. I do not know how to switch it ON. The preview always showed the Attachment names with the functional characters. So I had to place them at the end, which reversed their order at that.)